Intel NetStructure 470 Manual de usuario descargar pdf (Pagina 50)

CHAPTER 4

Intel

NetStructure™ 470T and 470F Switches User Guide

Configuring Community Strings and

Trap Receivers

A trap receiver is a computer on the network that is running an SNMP

management application and receives messages sent by the switch. For

example, the switch can send a trap to the trap receiver when it detects a

change in port speed.

To specify a trap receiver

1 Click the Configure Management menu, and then click Community

Strings and Traps.

2 In the IP Address box, type the IP address of the computer you want to

use as a trap receiver. You can specify up to four trap receivers.

3 In the Status box, click Enabled.

4 In the Community String box, type the trap receiver’s SNMP

application community string.

5 Click Submit.

NOTE

These are the traps supported by

the switch:

• Power to the switch was

cycled or reset.

• Link, speed, or other status

changes on a port.

• Authentication failure.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 154 155

Sin comentarios

Intel NetStructure 470 Manual de usuario Pagina 50