Intel NetStructure ZT8101 Manual de usuario Pagina 110

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 124
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 109
110 ZT8101 Users Guide
Using the Web Console
IP Address Filtering
You can manually configure the switch to drop packets from specified MAC and IP addresses. For
information about specifying MAC addresses to drop, see the Forwarding | Unicast MAC
Address Setting screen
To specify an IP address for filtering
1. In the left panel, click IP Address Filtering.
2. Click New and configure these fields:
3. Click Apply.
The entry is added to the table.
4. To remove an entry, select the entry in the table and click Remove.
MAC Address Priority
You can specify a MAC address so that packets with this address are given special handling, either
a higher or lower priority than normal traffic.
Note: If flow control is enabled, a small of amount of low priority traffic may be forwarded before high
priority traffic.
To set up a MAC address priority
1. In the left panel, click MAC Address Priority.
2. Click New and configure these fields.
Field Description
IP Address Specifies the IP address of the packets you want dropped.
Source/Destination
Specifies the condition for filtering the packets:
DestinationPackets with the above IP address as their destination
will be dropped.
SourcePackets with the above IP address as their source will be
dropped.
EitherAll packets with the above IP address will be dropped.
Field Description
MAC Address Specifies the MAC address to set a priority for.
Vista de pagina 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 123 124

Comentarios a estos manuales

Sin comentarios